Instructions for use and maintenance (I) Operation 1. Store the machine:When you open the package, please put the machine in the ventilation and dry house whose temperature is above 10 ºC. 2.Add the hydraulic oil: The oil port is on the oil box(nylon cover). Open the cover and add the hydraulic oil to the oil box as instruction in technical data. 3. Systematic pressure: The systemic pressure had been adjusted before the machine left out factory.You must not adjust it by yourself in case of damaging the machine. 4. Choose the dies: You should choose proper dies when you make hose assembly. NOTE: The number on the die is the min diameter of crimped.(the regulator is adjusted to zero) 5. Dies installation: The die is installed in the die base. Kindly change the dies like the photo shown:
6. Adjust the crimp size: Adjust the finally crimp size by Numerical Regulator. Turn the Numerical Regulator and the number be changed. At first, choose the suitable dies and then adjust Numerical Regulator. Note: finally crimp size=die size+Numerical Regulator size. E.g.: 14+2.5=16.5
Crimped Operation: crimped as following:
Choose and install the suitable dies as per the crimping data Adjust the numerical regulator as per the crimping data Press the regulator lamp switch to make sure it on work Screw down the unloading valve as per clockwise,clock the hydraulic outlet. Put hose into the machine head,press hand pump till the lamp be on. Anticlockwise loosen the unloading valve.The die open and put out the hose. (II). Maintenance and Notice: 1. High strength screw in frond of the machine should be regularly tightened, requiring at least six months, tightening torque to 34 ± 8Nm. Overload to bad working conditions should reduce maintenance cycles. 2. The working surface of the machine should keep clean (If the machine was not used for a long time). You ought to inject enough grease lubricant before the machine operates. 3. You should ensure the oil clean, otherwise it will decrease the life of machine. 4. Check the bolts on the moving and pressing spares of machine.If the bolts is loosen, please screw again. 5. To keep the operation and life-saving, the machine should have a run-in time of two to three months. During this period,you should avoid crimping the hose which have four layers of steel wire and maximum inside diameter is 25mm. 6.Notice the clamp injury risk!!! When machine is crimping, pls keep an enough safe distance between the crimping area and hold hose position, to avoid clip! While the machine is running, pls do not put your figures into the crimping head or into the dies base. 7.After work, pls make sure the dies are back to the largest open position. Do not keep the dies and die base in the locked situation when shutting down for long time. 8.Do not let children touch the machine, in case accident, 9.Do not rinse the machine, especially the machine head parts. 10.crimping machines only can use the original factory design and manufacture dies. The dies provided by any third party, install and use on the machines are beyond the scope of the warranty. We will reject all warranty obligations and responsibilities. Any lose and risk by use third-party dies will be borne by the consumer. 11. The standard dies are not suitable for half crimping. If you need to do half crimping, please make a new die. Use standard dies for half crimping, the dies and machine will be broken. In this condition, we also repair the machine but cost extra.
Packaging & Shipping
The general packing for crimping machine usually is wooden box .